Pulse configuration
Running the pulse driver with different pulse lengths
The step-by-step guide below changes one setting of the basic configuration.
In 5 steps, the pulse length is changed from its current value to Large.
| Configured set |
Selection via DIP switch |
| Small | 50, 100, 150, 300 milliseconds |
| Medium | 150, 200, 250, 300 milliseconds |
| Large | 500, 700, 900, 1000 milliseconds |
| XL | 1200, 1400, 1800, 2000 milliseconds |
| XXL | 5, 6, 7, 8 seconds |
| 3XL | 10, 20, 30, 40 seconds |
One of the values from the configured set (S to 3XL) can be activated via the DIP switches on the pulse generator.
This step-by-step guide can also be used to set one of the other sets. To do so, use an alternative step 5, as shown in the last paragraph below.
Lost track halfway through the step-by-step guide? No problem: just disconnect the power supply and go back to the start!
This configuration can only be adjusted for pulse generators with version number S3. Do you own an S1 or S2? Then please contact us.
Starting up in test mode
Step 1
Disconnect the (battery) connector or USB.
Step 2
Hold down TIK and reconnect the power supply at the same time.
The pulse generator is now starting up in test mode, recognizable by:
- A pulse every second
- LED flashes in sync with the pulse
Proceed to configuration mode
Step 3
Set DIP switch to 2, 3, and 4 ON
Hold down TIK (for approx. 7 seconds) until the LED has flashed very rapidly for one second as confirmation.
The pulse generator is now in configuration mode, recognizable by:
- LED on with one short cyclical interruption
- No pulses
If the TIK button is not used for more than 30 seconds, the pulse generator will automatically configuration mode exit by restarting.
Set pulse length
Step 4
Set DIP switch: all to OFF
(= selection: set pulse length)
Hold down TIK, until the LED has blinked very rapidly as confirmation.
- The LED remains on for a long time after this, with two short interruptions each time.
Step 5
(= setting selection: Large)
Hold down TIK, until the LED out / On / out go.
The new setting has now been saved. and the pulse generator restarts. From now on, the new pulse length will always be used!
Step 5 alternative
By using one of these DIP switch values in Step 5 , different pulse lengths can be configured: